[. . . ] After removing the transport lock screws, place the supplied seals over the screwholes. After removing the three transport lock screws, place three pieces of the small plastic film (supplied) over the three screw holes to prevent water entry. To prevent a short-circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the changer is to be installed in a vehicle equipped with an on-board drive or navigation computer, do not disconnect the battery cable. [. . . ] Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion. Quite los pernos hexagonales adhiriendo los soportes (A) a la base de montaje (B) y quite el cambiador de la base (Paso 3 para referencia). Using a knife, cut holes in the carpet directly above the bracket's bolts. Mettez la bande à deux faces fournie en bas des bases de montage (B) et éplucher le support en papier. Use the hexagonal nuts to re-attach the changer, on top of the carpet, to the mounting bases (B). Make sure the anti-vibration springs are set to position "90". Attach a bracket (A) bracket to each side of the unit using the machine screws (M4x5). Attach the brackets (A) to the mounting base (B) using the hexagonal bolts (M6x12) and M6 flat and split washers. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion. Quite los pernos hexagonales adhiriendo los soportes (A) a la base de montaje (B) y quite el cambiador de la base (Paso 3 para referencia). Using a knife, cut holes in the carpet directly above the bracket's bolts. Mettez la bande à deux faces fournie en bas des bases de montage (B) et éplucher le support en papier. Use the hexagonal nuts to re-attach the changer, on top of the carpet, to the mounting bases (B). Make sure the anti-vibration springs are set to position "45". Attach a bracket (A) to each side of the unit using the machine screws (M4x5). Attach the brackets (A) to the mounting base (B) using the hexagonal bolts (M6x12) and M6 flat and split washers. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. [. . . ] Grip the tab on the magazine tray into which you will be loading a disc and pull it out gently. Insert a disc into the tray with the label side up (play surface facing down). NOTE: This unit is not designed to play 3" (8cm) CD-Single discs. Inserting a 3" disc into the magazine, either with or without a 3" disc adaptor, can damage the changer and the disc. [. . . ]